Vertical Termination With CO-LINEAR Flex System | Regency P33-NG3

INSTALLATION

VERTICAL TERMINATION

WITH CO-LINEAR FLEX SYSTEM

THE APPLIANCE MUST NOT BE CONNECTED TO A CHIMNEY FLUE SERVING A SEPARATE SOLID FUEL BURNING APPLIANCE.

This appliance is designed to be attached to two 3" (76mm) co-linear aluminium ﬂ ex running the full length of the chimney. See the Venting Arrangements on next page for minimum and maximum heights.

Required Parts:

Part #	Description
946-529	Co-linear DV Vertical
	Termination Cap
948-305	3" Flex - 35 ft.
946-563	Co-Axial to Co-Linear Adapter
Kit
	which contains the following:
	Co-linear Flex Adapter
	Outer Pipe
	Inner Pipe Adapter
510-994	Rigid Pipe Adaptor

Masonry chimneys may take various contours which the ﬂ exible liner will accommodate. However, keep the ﬂexible liner as straight as possible, avoid unnecessary bending.

The Air Intake pipe must be attached to the inlet air collar of the termination cap.

Co-linear DV
Vertical Termination
Cap # 946-529
A maximum
of two certified
joiner kits
may be used
per length.	Flex Liner
#948-305
35 ft (11m)

94545o Elbow

Alternate Approved Caps

980Vertical Termination Cap

991High Wind Cap

923GK 3" Co-linear Adapter with ﬂ ashing

FPI Cabinet and/or Flat Wall Mantles may be used in these applications en- suring that clearances to combustibles are maintained.

Exhaust

Flue

Outer

Pipe

with Kit# 946-563

Pipe Length

Air Intake

Rigid Pipe Adaptor

# 510-994

45o Elbow

Inner Pipe

Adapter with Kit# 946-563

Co-Linear

Flex

Adapter with Kit# 946-563

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace

Image 21

Regency P33-NG3 Vertical Termination With CO-LINEAR Flex System, Required Parts, Description, Alternate Approved Caps

Contents

P33-3 Zero Clearance To the New Owner Information for MOBILE/MANUFACTURED Homes After First Sale Table of Contents Safety Label General Safety Information InstallationSave These Instructions Before YOU Start Unit Dimensions Installation ChecklistLocating Your GAS Stove Duct System Option Mantel LEG Clearances Clearancescombustible MantelsClearances are not adhered to Fire hazard is an extreme risk if these Rear Termination Framing and FinishingSimpson Dura-Vent Minimum Clearances Vertical Termination or Vertical Rise with Horizontal Top Standoff Assembly Unit Assembly Prior to InstallationVenting Introduction Top Facing Support Side Nailing Strips Vent terminal Air supply outlet Vent Regency Direct Vent System Flex Horizontal Terminations only For Regency Direct Vent System Flex Installation Procedures Rigid Pipe Venting Systems Flat Wall InstallationMax. Wall Vent Length Thickness inches Required inches Rigid Pipe Venting Components List Description Simpson Dura-Vent SelkirkDirect VentGS R Direct-Temp TM Propane & Natural Gas Rigid Pipe Venting Arrangements Vertical Terminations Installation Regency Direct Vent System Flex Rigid Pipe Venting Arrangements Horizontal Terminations Horizontal Venting with Two 2 90o Elbows Horizontal Venting with Three 3 90o ElbowsOption + H1 Option + V1 H + H1 Vertical Venting with Two 2 90o ElbowsOption + V1 With these options, max. total Vertical Venting with Three 3 90o Elbows Required Parts Vertical Termination With CO-LINEAR Flex SystemDescription Alternate Approved Caps Installation Horizontal Installations Below Grade Snorkel InstallationSnorkel Terminations Vertical Termination GAS Line Installation GAS Pipe Pressure Testing Pilot AdjustmentHigh Elevation T. Valve Description Conversion Kit Contains Optional Brick Panels LOG SET InstallationNotch BracketBracket Optional Flush Trim Standard Flush DoorCutout 5th Grate Tab Double Screen Door Flush LouversOptional BAY Door Bay louvers Must be used With the Bay glass option Flush Louver Top Heat Shield BAY LouversBay Louver Top Heat Shield Burner ON/OFF Control box Full Screen Front Cut-Out Oblong Hole Top Flange BottomCut-Outs Top Grill Hinge Location Bottom Grill Thermostat Wire Table Optional Wall Switch Do not cut the ground terminal off under any circumstances Wiring Diagram Shut the power off Installing the Optional FANDiagram Secure left side with 2 screws Secure the 2 boxes together With one screw Copy of the Lighting Plate Instructions Operating Instructions Shutdown Procedure Lighting ProcedureAeration Adjustment Operating Instructions Maintenance Instructions MaintenanceLOG Replacement Normal Operating Sounds GAS Appliances Thermopile Thermocouple Flush Glass ReplacementGlass Gasket Door Glass Diagram 3 Lift out Valve Tray Assembly Installing ValveRemoving Valve Shut off the gas supply Description Parts List Parts List Part Description Burner & Log Assembly Flush Front & Louvers Bay Front & Louvers Regency P33-3 Zero Clearance Direct Vent Gas Fireplace Conditions Warranty Installer Please complete the following information