INSTALLATION
8) Pull off ember size pieces of rockwool and gently place them on the front of the burner trayintheplacesshowninthephotobelow.Do
250
not compress the rockwool, leave it loose.
253
254
6)Place the bottom left front edge of Log 251 against the left edge of the burner tray and rest the log on the cutout on Log
253.
250
Diagram 1
Place rockwool in these 2 locations
on the burner tray.
251
253 | 254 |
Cutout
9)Test fi re to ensure proper light off (make sure fl ame fl ows smoothly from one end of burner to the other). If there is any fl ame hesitation, check that area for any blockage of the burner ports.
10)Install fl ush glass and bay glass (if used) as
Diagram 2
Use the hook to pull the spring out until you can put the hook into the slot on the bottom door bracket. Repeat for 2nd spring. See diagram 3.
7)Position Log 252 across the cutouts in Logs 254 and 253. The notch in the bottom right end fi tting against the 5th grate tab.
252
253 | 254 |
|
5th Grate Tab
|
| 250 | |
251 |
| 252 | |
253 | 254 | ||
|
STANDARD FLUSH
DOOR
The standard flush door comes with a black frame. To install the frame, simply hook the top door fl ange onto the top of the unit and swing the door towards the unit, diagram 1. Be care- ful that the glass gasket does not roll up; there must be a gap between the gasket and the door lip to ensure that the door sits securely on the unit. Diagram 2.
Diagram 3
To remove the fl ush door, reverse the above steps.
Optional Flush Trim
Attach the round magnets to the back of the top trim piece and to the bottom trim piece, then at- tach trim to the top and bottom of Flush door.
Regency
