INSTALLATION

FLUSH LOUVERS

1)Install the top louver by sliding the two bracket clips into the brackets located un- derneath the top of the fi rebox.

2)Install the bottom louver by folding the louver down and then sliding the Bottom Louver bracket down onto the 2 pins on the base of the unit (dia. 1). Secure with 1 screw as per dia. 2.

DOUBLE SCREEN

DOOR

1)Pull out the top louver.

2)Center the screen door and hook over the fl ush door.

Diagram 1

Diagram 2

3) Open the screen door(s) and secure the screen door to the fl ush door front with 2 clips on the bottom left and right side.

Note: Top and bottom louvers are different.

3)Open the bottom louver. Pull the Burner ON/OFF control box from inside the bottom of the fi replace and position the slots in the bracket over the 2 screws on the left side of the bottom louver. Push down to lock into place. Tighten the screws.

 

Note: If any maintenance etc. must be done

 

in the firebox, first remove the Bay

 

louvers and door.

 

Optional Bay Trim

Clip locations

Attach 4 supplied magnets each to the back of

 

the top and bottom trim pieces, and attach trim

 

to the top and bottom of Bay door.

Clip installed on right side.

OPTIONAL BAY DOOR

The Bay louvers MUST be used

with the Bay glass option.

Screws on lou-

Burner ON/OFF

ver bracket

control box

Burner ON/OFF control box attached to bot-

tom fl ush louver.

The optional Bay door is an overlay on the flush front. The standard fl ush door and glass must remain on the unit.

1)Hook the top of the bay door over the fl ush door fl ange and swing the bottom against the bottom fl ange of the fl ush door.

2)Secure to the fl ush door bottom bracket with 2 screws provided.

3)Slide the valve extension knobs onto the valve knobs.

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace

Page 29
Image 29
Regency P33-NG3 Flush Louvers, Double Screen Door, Optional BAY Door, Bay louvers Must be used With the Bay glass option