Regency P33-NG3, P33-LP3 Optional Brick Panels, LOG SET Installation, Notch, BracketBracket

INSTALLATION

OPTIONAL BRICK

PANELS

1)Undo the bottom 2 door latches and open and remove glass door. Remove logs.

2)Attach the 2 Rear Brick Retaining clips to the rear wall. Loosen the screws in the top and rear wall of the fi rebox and slide the retaining clips into position (tight against the fi rebox top) and then tighten the screws.

LOG SET INSTALLATION

D) 251 A) 250

Readtheinstructionsbelowcarefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.

Log Kit # 431-930 contains the fol-

The 3-digit numbers (i.e. 250) are molded into the rear of each log.

C) 253 B) 254 E) 252

Note: The logs must not be in the unit.

3)Insert the back brick panel by carefully slip- ping it between the back wall of the fi rebox and the rear log bracket.

4)Put the side panels in next. Slide them in from the front and push them fl at up against the wall. Be very careful not to scratch them on the fi rebox hardware.

lowing pieces:
A)	250	Rear Log	902-250
B)	254	Middle Cross Log	902-254
C)	253	Front Left Cross Log	902-253
D)	251	Rear Left Log	902-251
E)	252	Front Right Cross Log	902-252
F)		Embers	902-156
G)		Vermiculite	902-179/21
H)		Rockwool	902-153

NOTE: If you will be installing the optional Brick Panels, install the Brick Panels prior to installing the logs.

1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.

2)Sprinkle the vermiculite and embers around the fi rebox base.

4)Place Log 254 on the front right side of the burner. Push the back of the log against the 2 brackets with the notch on the bottom right side of the log fi tting into the right side of the grate.

Notch

254

BracketBracket

250

254

5)Slide the Top Brick Panel into position and slide the Top Brick Retaining clips so that they hold the Top Brick Panel in place and tighten down the screws.

5) Position Log 253 across the cutouts in Logs

Vermiculite Vermiculite Vermiculite 250 and 254 with the notch on the left side of the log fi tting into the 2nd grate tab.

3) Place the Log 250 on the rear log support

pins with the fl at side to the back.	Cutouts
	253
250
	250
	254
	2nd Grate Tab

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace