RGB Spectrum 201 manual Figure below illustrates the System Tab

O P E R A T I O N

.S

	.
	Options Menu
	. . .
	~ Use the Mode drop down menu to select between the
	Playback and Free-run modes. In the Free-runmode
	the output timing parameters are set by the user. In the
	Playback mode the output timing parameters are
	automatically loaded to match the format of the clip that
	is being played.
	~ Use the Test Pattern drop down menu to select a test
	pattern to display on the output port. The test pattern
	provides a simple way to confirm that the output is
	correctly connected to a display device.
	~ Use the Gamma spin box to change the gamma of the
	playback image for both analog and DVI outputs.
	Note: The gamma of the input image recorded to disk is
	preserved. The Gamma control does not apply to the
	input image.
	~ Use the Timing List section of the Output page to set
	the output format. To select a new Output format, select
	the required format from the drop down Timing list and
	click on the Load button. The timing parameters
	associated with the format are listed in the Video
	Output Timing section of the Output page. These
	parameters may be changed by clicking on the Edit
	button and making the required changes to the
	parameters in the Video Output Timing fields. This
	new setting may then be saved to the Timing List by
	selecting an unused entry in the list and clicking the
	Save button. Unwanted entries to the Timing List can be
	deleted by selecting the timing entry that you wish to
	delete in the drop down Timing List box, and clicking on
	the Delete button.
. . . . . . . . .	The figure below illustrates the System Tab.
SYSTEM TAB
	The System Tab is used to view and set communications parameters in
	addition to setting the DGy 201’s internal clock.

350-8697 DGy Model 201 User Guide 56