RGB Spectrum 201 manual Command Arguments Description, RECordLOOP

C O M M A N D L I N E I N T E R F A C

.E

		.
		Command Summary
		. . .
Table 6-10.DGy 201 Play and Record Commands (Continued)
Command	Arguments	Description
RECordFrameRate	<0 .. 100>	Sets the rate at which input frames are recorded.
		This command would most likely be used to save
		disk space by recording at a lower frame rate. For
		example, a 1280 x 1024 image can typically be
		recorded at 30 frames/second.
		RecordFrameRate 15 would record at half the
		rate, with double the available recording time.
		An argument of 0 always allows recording at the
		maximum rate which is calculated automatically by
		DGy.
		Factory default: 0
RECordBitRate	<0.1 .. 8.0>	Sets the degree of compression i.e. quality level
		(Stated in bits/pixel).
		RECordBitRate effectively controls the trade-off
		of bit-rate versus quality. Without regard to
		recording frame rate, an argument of 0.1 reflects a
		240:1 compression, with an argument of 8
		reflecting a 3:1 compression. (Compression is
		measured relative to a 24-bit pixel)
		Quality levels are related to compression level, for
		example:
		RECordBitRate 0.7 is low quality
		RECordBitRate 1.0 is medium quality
		RECordBitRate 1.5 is high quality
		Factory default: 1.0 (medium quality)
RECordLOOP	<ON OFF>	If RECLOOP is ON, recording will be continuous.
		Note that only the current clip is overwritten. Disk
		overwrite will begin when there is only 4 GB of
		remaining disk space. Overwrite begins with the
		oldest part of the clip.
		Factory default: OFF

350-8697 DGy Model 201 User Guide 105