OPERATIONS
Options Menu
350-8697 DGy Model 201 User Guide 58
. . . . .
Figure 3-21. Restart Warning Message
Serial Communications settings are also set in the Systems Page.
Available baud rates range from 9600 baud to 115,200 baud, but it is
recommended to use the default baud rate (115 kbaud). Use the
following procedure to change the serial port parameters.
•In the Serial Port section:
~Use the pull-down Baud Rate menu to set the baud rate
for the system’s RS-232 serial port. The default value is
115,200 baud.
~Check the Echo On box to enable echo.
SETTING THE DGy DATE AND TIME
The DGy 201 uses an internal real time clock to time stamp the
recordings.
You can manually set the time and date, or use the time and date setting
of the PC that is running the copy of WCP that you are using to control
DGy 201.
•In the Clock section:
~Click Sync to PC to load your PC’s “local” time into the
DGy 201’s temporary clock register.
~Use the Date and Time up/down selectors to adjust the
date and time as necessary.
~Identify the Time Zone that your DGy 201 is located in
by using the drop down Time Zone box.
~Click Apply to upload the new time setting into DGy
201’s active clock register.
OR
~Use the drop down entry boxes to manually set the Date
and Time
~Identify the Time Zone that your DGy 201 is located in
by using the drop down Time Zone box.