Sending by IP-Fax

Sending by IP-Fax

IP-Fax function uses TCP/IP (LAN or Internet), and the same procedures as the standard fax function. Functions available in both standard and IP-Fax transmission can be used in generally same manner.

By connecting your machine to a gateway (T.38-compliant) or gate- keeper, you can send to a standard G3 facsimile connected to the public switched telephone network (PSTN) via TCP/IP.

Preparation

Make the necessary System Settings beforehand. See “Network Guide.”

Note

❒If you have set “Enable H.323” and “Enable SIP” parameters to “On” with “IP-Fax Settings” under “Fac- simile Features”, [VSelect Protocol] appears. Press this button to select a protocol to be used.

❒To send via the Internet, the receiv- er’s machine must also be connect- ed to the Internet. You cannot send to a firewall-protected network.

❒For a list of gateways (T.38-compli- ant) or gatekeepers that are certi- fied as operable with this machine, contact your local reseller or serv- ice provider.

❒When using the transfer request function, you can specify the IP- Fax destination to the transfer sta- tion. See p.88 “Sending the Trans- fer Result Report”, Facsimile Reference <Advanced Features> .

❒When you specify the IP-Fax trans- mission under Sender Settings , a transmission result notification mail is sent to the destination . See p.81 “Communication Result Re- port (Memory Transmission)”, Facsimile Reference <Advanced Fea- tures> .

A Press to switch the destination to IP-Fax number.B Specify the IP-Fax destination of the receiver.

Reference

p.35 “Entering an IP-Fax Destination ”

p.38 “Using Destination Lists”

p.47 “Redial”, Facsimile Reference <Advanced Features>

Note

❒When both the H.323 setting and SIP setting are set to ON under [IP-Fax Settings] of [Fac- simile Features], [Protocol] ap- pears. Press [Protocol] to select the protocol you want to use.

3

71