Memory Unit TypeB 64MB
G Place the controller board on a flat surface.
H Insert the Memory unit to the slot by placing the notch of the unit to the projection of the slot, and then push it down until it clicks.
ZGDX130J |
K Fasten the controller board to the printer with the two screws.
2 |
ZGDX270J |
Note
❒If the Duplex Unit is not at- tached, go to step N.
I Match the controller board to the top and bottom rail using the "T" mark, and then slide it into the printer slowly until it stops.
ZGDX250J |
J Push the handle of the controller board until it clicks.
L While aligning the power cord to the left side groove of the Duplex Unit, slide the Duplex Unit in un- til it is connected to the printer.
ZGDX240J |
M Attach the interface cable to the printer.
ZGDX380J
19
