Installing Options
E Pull out the handle of the control- ler board.
2
ZGDX370J
F Pull the handle and slide the con- troller board out.
ZGDX261J |
G Place the controller board on a flat surface.
H Use a coin to remove the two screws, and then remove the cover.
Note
❒These screws are used again in step J.
❒The removed cover is not used when installing the Network In- terface Board.
22 | ZGDX410J |
I Insert the end of the Network In- terface Board into the opening (A), and then push down until it clicks (B).
ZGDX422J |
ZGDX432J |
J Fasten the Network Interface Board to the controller board.
ZGDX441J |
