802.11b Interface Unit Type A
M Push back the handle of the con- troller board until it clicks.
ZGDX380J
N Fasten the controller board to the printer with the two screws.
ZGDX273J |
P Plug the printer's power cord back into the wall outlet, and then turn on the power switch.
You need to make settings with the control panel before using the 802.11b Interface Unit.
Note | 2 |
| |
❒ After installing the last option |
|
| |
that you want, print the config- |
|
uration page to confirm the in- |
|
stallation. If the new device is |
|
listed in the column of configu- |
|
ration options, then it has been |
|
properly installed. For more in- |
|
formation about printing the |
|
configuration page, see "Print- |
|
ing the Configuration Page" in the |
|
Printer Reference on the CD- |
|
ROM labeled "Operating In- |
|
structions". |
|
Note
❒If the Duplex Unit is not at- tached, go to step P.
O While aligning the power cord to the left side groove of the Duplex Unit, slide the Duplex Unit in un- til it is connected to the printer.
ZGDX243J |
31
