Installing Options
G Place the controller board on a flat surface.
H Use a coin to remove the two screws, and then remove the cov- er.
2 | Note |
❒ These screws are used again in |
step J.
ZGDX410J |
I Attach the 802.11b Interface Unit.
Insert the end of the 802.11b Inter- face Unit into the opening (A), and then push down until it clicks (B).
ZGDX420J |
ZGDX431J |
J Fasten the 802.11b Interface Unit to the controller board with the two screws.
ZGDX442J |
K Insert the card slowly into the 802.11b board with the label fac- ing down and the uneven black antenna surface facing up until it stops.
ZGDX500J |
L Match the controller board to the top and bottom rail using the "T" mark, and then slide it into the printer slowly until it stops.
ZGDX251J |
30
