Configuring the Printer for the Network
3
44
J If you use NetWare, select the frame type for NetWare.
Select one of the items below if necessary.
•Auto (Default)
•Ethernet 802.3
•Ethernet 802.2
•Ethernet II
•Ethernet SNAP
Note
❒Usually, use the default setting (“Auto”). When you first select “Auto”, the frame type detected by the printer is adopted. If your network can use more than two frame types, the print- er may fail to select the correct frame type if “Auto” is selected. In this case, select the appropri- ate frame type.
A Press {U} or {T} to display “Frame Type (NW)”.
Network Setup:
Frame Type (NW)
BPress {Enter #}.
The current setting appears on the panel display.
Frame Type (NW): *Auto
C Press {U} or {T} to display the frame type you want to use.
DPress {Enter #}.
K Select the interface.
Ethernet and IEEE 802.11b appear only when both the Network Inter- face Board and the 802.11b Inter- face Unit are installed.
Select one of the items below.
•Ethernet
•IEEE 802.11b
A Press {U} or {T} to display "LAN Type".
Network Setup:
LAN Type
BPress {Enter #}.
The current setting appears on the panel display.
CPress {U} or {T} to display "Ethernet".
LAN Type: *Ethernet
DPress {Enter #}.
L Press {On Line}.
On Line | Menu |
|
Job Reset | Escape |
|
Form Feed | Enter |
|
Power | Error | Data In |
ZFDP010N
"Ready" appears on the panel dis- play.
Ready
M Print a configuration page to con- firm the settings made. See "Printing a Configuration Page" in the Printer Reference.
The settings are now complete. Go to p.51 “Installing the Printer Driv- er and Software”.
