1394 Interface Unit Type 4510
J Fasten the 1394 Interface Unit to the controller board.
ZGDX443J |
K Match the controller board to the top and bottom rail using the "T" mark, and then slide it into the printer slowly until it stops.
ZGDX252J |
L Push back the handle of the con- troller board until it clicks.
M Fasten the controller board to the printer with the two screws.
2 |
ZGDX272J |
Note
❒If the Duplex Unit is not at- tached, go to step O.
N While aligning the power cord to the left side groove of the Duplex Unit, slide the Duplex Unit in un- til it is connected to the printer.
ZGDX242J |
O Plug the printer's power cord back into the wall outlet, and then turn on the power switch.
You need to make settings with the control panel before using the 1394 Interface Unit.
ZGDX380J
27
