Installing Options
Connecting the Network Interface Cable to the Network
A Turn off the power switch.
B Loop the network interface cable
2 | and attach the ferrite core. |
|
Note
❒The network interface cable loop should be about 15 cm (6") (A) from the end of the cable (on the end closet to the print- er). The ferrite core at the end of the cable should be a ring type ferrite core.
ZDDP320E |
C Attach the network interface ca- ble to the jack on the Network In- terface Unit.
ZGDX291J |
D Connect the other end of the net- work interface cable to the net- work.
E Turn on the power switch.
Note
❒After installing the last option that you want, print the configuration page to confirm the installation. If the information about network set- tings (e.g. IP address) is listed in the configuration page, then it has been properly installed. For more information about printing the configuration page, see "Printing the Configuration Page" in the Printer Reference on the
24
