Ricoh 400780, Type B Printing with IP over, Inactivating the Device, Preparation, Limitation

Installing the Printer Driver Using IEEE 1394

Printing with IP over 1394

You can print by setting the IP address for this machine and the computer on which Windows XP is installed.

Preparation

"IP over 1394" must be set on the control panel and an IP address for the IEEE 1394 must be specified.

For more information about how to make printer settings, see p.45 “IEEE 1394 Configuration”.

Limitation

❒When using the IEEE 1394 (IP over 1394) interface in a network, the Ethernet

interface cannot be used in the same network. 4

Note

❒The maximum number of simultaneous print requests when connecting with IP over 1394 includes the print requests from the Ethernet interface. For more information, see the Network Printing Guide.

Installing the Printer Driver

To Print using Standard TCP/IP port. For more information about Standard TCP/IP port settings, see Network Printing Guide.

-Inactivating the Device

❖When [Add New Hardware Wizard] starts every time you restart the computer with an operating system, which does not support SCSI print or plug in or out the cable, inactivate the device by following procedures.

•Windows Me

A In the [Add New Hardware Wizard] dialog box, confirm that [Windows has found the following new Hardware: IEEE SBP-2 Device] is displayed, and se- lect [Recommended search for a better driver [Recommended]], and then click [Next>].

B When the [Windows was unable to locate the software for this device.] mes- sage appears, click [Finish].

71