Network Interface Board Type 2610
K Match the controller board to the top and bottom rail using the "T" mark, and then slide it into the printer slowly until it stops.
ZGDX253J |
L Push back the handle of the con- troller board until it clicks.
N While aligning the power cord to the left side groove of the Duplex Unit, slide the Duplex Unit in un- til it is connected to the printer.
2 |
ZGDX241J |
O Plug the printer's power cord back into the wall outlet, and then turn on the power switch.
ZGDX380J
M Fasten the controller board to the printer with the two screws.
ZGDX271J |
Note
❒If the Duplex Unit is not at- tached, go to step O.
23
