IEEE 1394 Configuration
IEEE 1394 Configuration
Use this procedure to configure the printer for use in the IEEE 1394 envi- ronment. The following table shows the control panel settings and their default values. These items are in- cluded in the "Host Interface" menu.
Setting Name | Value |
|
|
IP Address1394 | 000.000.000.000 |
|
|
Subnet Mask1394 | 000.000.000.000 |
|
|
IP over 1394 | Active |
|
|
SCSI print | Active |
|
|
Active | |
|
|
Depending on the protocol you use, procedures vary. See the following ta- ble.
IP over 1394 | Steps |
| go to steps M to N |
|
|
SCSI print | Steps |
| go to steps I to N |
|
|
A Press {Menu}. |
|
On Line | Menu |
|
Job Reset | Escape |
|
Form Feed | Enter |
|
Power | Error | Data In |
|
| ZFDP020N |
“Menu” appears on the panel dis- play.
B Press {U} or {T} to display “Host Interface” menu.
Menu:
Host Interface
C Press {Enter #}.
On Line | Menu |
|
Job Reset | Escape |
|
Form Feed | Enter |
|
Power | Error | Data In |
ZFDP060N
The following message appears on the panel display.
Host Interface:
I/O Buffer
D Press {U} or {T} to display “IEEE 1394 Setup”.
Host Interface:
IEEE 1394 Setup
E Press {Enter #}.
The following message appears on the panel display.
IEEE 1394 Setup:
IP Address1394
F Press {U} or {T} to display “IP over 1394”.
IEEE 1394 Setup:
IP over 1394
APress {Enter #}.
BPress {U} or {T} to select ei- ther "Active" or "Not Active".
CPress {Enter #}.
The display returns to the previ- ous menu in a few seconds.
3
45