RIDGID WL1200LS1 manual Mounting the Motor, M6 x Hex Head Screw Carriage Bolt, Hex Nut, X 19 x

7.Locate Hole F on the left table board. Attach the bracket plate to the table top through Hole F. Use an M6 x 1.0- 45 carriage bolt, washer, lockwasher and nut. Finger tighten.

8. Locate the three holes Labeled G on
the lower edge of the belt guard plate.
Place a M4 x 0.7-6 screw through	G
each of these holes and into the
tapped holes in the plate support.	G
9. Replace pulley on headstock tighten-	G
ing with 4mm hex “L” wrench.
10. Securely tighten all nuts and bolts.

M6 x 1.0-12

Hex Head Screw

M6 x 1.0-45

Carriage Bolt

Mounting the Motor

1.Find the following:

1Motor

1Motor Pulley

2Cord Clamps

1V-Belt

2.From the loose parts package find the following:

2M4 x 0.7-6 Pan Head Screws

4M6 x 1.0-16 Carriage Bolts

46.5 x 19 x 1.6 Flat Washers

46mm Lockwashers

4M6 x 1.0 Hex Nuts

1M8 x 1.25-8 Socket Set Screw

14mm Hex “L” Wrench

Motor Cord Clamp Motor Pulley

Pan Screw

M4 x 0.7-6Carriage Bolt

V-Belt

M6 x 1.0-16

Washer	Lockwasher	Hex Nut
	6mm
6.5 x 19 x 1.6		M6 x 1.0

4mm Hex “L”

Socket Set Screw Wrench M8 x 1.25-8

15