RIDGID WL1200LS1 Holes Used for Mounting Boards and Wood Lathe to Leg Set, Board/Side Support

Assembly (continued)

Holes Used for Mounting Boards and Wood Lathe to Leg Set

	G	H	H
J		H	H
	G		A	B
		F
J	G
C				D
		E
C				D
				K
		E	A	B
A - Board/Side Support				F - Bracket Plate/Plate Support/Board/
B - Board/Side Support				Side Support
C - Plate Support/Board/End Support				G - Belt Guard/Plate Support
D - Board/End Support				H - Motor/Plate Support
E - Headstock/Plate Support/Board				J - Cord Clamps/Plate Support
				K - Rear Foot/Board

Mounting Left Side Table Top

1.Find the following:

1Particle Board Table Top

1Plate Support (Steel)

2.From the loose parts package find the following:

4M6 x 1.0-45 Carriage Bolts

4 M6 x 1.0 Hex Head Nuts

46.5 x 19 x 1.6 Flat Washers

46mm Lockwashers

3.Position the table top on the left side of the assembled legset as shown

4.Front Side Stiffeners

Face the front of the legset and count over from the left one slot and one hole. Place a carriage bolt through the table top (hole A) and the side stiffener. Fas- ten in place with a washer, lockwasher and nut. Finger tighten only.

5.Rear Side Stiffener

Face the rear of the legset and count over from the right two holes. Place a carriage bolt through the table top (hole A) and the side stiffener. Fasten in place with a washer, lockwasher and nut. Finger tighten only.

6.Locate the two holes marked C in the steel plate support. Place bolts;

- through these holes

-through the two holes marked C on the table top

-and through the holes marked C in the End Stiffener. Place a washer, lockwasher and nut on these bolts. Finger tighten only.

Particle Board Table Top

Plate Support (Steel)

Carriage Bolt

M6 x 1.0-45

Flat Washer Lockwasher	Nut Hex
6.5 x 19 x 1.6 6mm	M6 x 1.0

12