On-off Switch
WARNING: To prevent serious personal injury, do not connect pow- er cord to electrical outlet in your shop until you are sure that motor ro- tation is correct (see page 9).
The
This Feature Is Intended To Prevent Unauthorized And Possible Hazard- ous Use By Children And Others.
1. Insert key into switch.
NOTE: Key is made of yellow plastic.
2.To turn lathe On... Insert finger under switch lever and pull End of switch out.
3.To turn lathe Off... Push lever in.
Never leave the lathe unattended until it has come to a complete stop and you have removed the switch key.
Do not cycle the motor switch on and off rapidly, as this may cause the faceplate or sanding disc to loosen. In the event this should ever occur, stand clear of the face plate or sanding disc until it has come to a complete stop... retighten it.
4.To lock switch in Off position... Hold switch In with one hand, Remove key with other hand.
Yellow
Switch Key
WARNING: To prevent unautho- rized use, always lock the switch “OFF". When lathe is not in use...
remove key and keep it in a safe place.
WARNING: In the event of a power failure (all of your lights go out) turn switch off... lock it and remove the key. This will prevent the risk of injury from the lathe starting up again when the power comes back on.
Speed Chart (Illustration for reference only.) See chart on belt guard assembly.
WARNING: Always use lowest speed when starting a new workpiece, using faceplate, or turning between centers to avoid possible injury.
23
