RIDGID WL1200LS1 manual Mounting Right Side Table Top, Particle Board Table Top Carriage Bolt M6 x

Mounting Right Side Table Top

1.Find the following:

1Particle Board Table Top

2.From the loose parts package find the following:

4M6 x 1.0-45 Carriage Bolts

4 M6 x 1.0 Hex Head Nuts

46.5 x 19 x 1.6 Flat Washers

46mm Lockwashers

3.The right side mounts similar to the left except there is no steel support plate.

4.Place carriage bolts, through the table top holes B and D as shown. Align the right side table top with the left side table top so that the two halves join end to end. Fasten in place with a washer, lockwasher and nut.

5.Securely tighten all nuts and bolts.

6.Adjust leveling feet as follows:

a.Move legset to desired location.

b.With a 14mm wrench loosen bottom nut.

c.Back off top nut by hand.

d.Raise or lower foot by adjusting bot-

tom nut using 14mm wrench.

e. Snug top nut against inside of leg by hand.

f. Tighten all four bottom nuts using 14mm wrench.

Particle Board Table Top

Carriage Bolt

M6 x 1.0-45

Flat Washer	Lockwasher	Nut Hex
6.5 x 19 x 1.6	6mm	M6 x 1.0

Motor Mounting Plate		Right Side
		Table Top
C
C		D
A	B	D
A		B

C

C

Left Side

Table Top

C

13