RIDGID WL1200LS1 manual Headstock, Tailstock, and Tool Rest Assembly, Tube Large Tool Rest

Headstock, Tailstock, and Tool Rest Assembly

1.Find the following:

1Tube

1Large Tool Rest

1Tailstock

2Lever Assembly

1Hex Head Screw M10 x 1.5-30

1Tool Rest Holder/Clamp Support Assembly

2Brass Shoe Locks

2.Place the tube assembly on your work- bench as shown. Always keep the squared key section straight down.

3.Slide the tube into the headstock until it stops against the squared key section. Insert hex head screw and tighten securely.

4.Slide the tool rest holder/clamp support assembly onto the middle of the tube. Assemble lever assembly as shown.

NOTE: Make sure to insert brass shoe lock before installing lever assembly.

Tube	Large Tool
	Rest
Lever
Assembly	Hex Hd Screw
Tailstock	M10 x 1.5-30

Brass Shoe

Tool Rest Holder Lock

Clamp Support

Assembly

Tube Assembly

Squared Key Section

Headstock Spindle

Spindle Pulley

Tube

Hex Head

Locking Screw

in Rear of

Headstock

Squared Key

Section

Clamp Support

Headstock

End

Brass Shoe

Lock Lever

Assembly

17