Roberts Gorden HE30ST, HE20ST, HE50DL, HE45UT, HE30DL, HE50ST, HE35UT General Suspension Details

SECTION 5: GENERAL SUSPENSION DETAILS

SECTION 5: GENERAL SUSPENSION DETAILS

WARNING

Severe Injury Hazard

Secure burner to burner tube with bolts and lockwashers.

Hang heater with materials with a minimum working load of 75 lbs (33 kg).

Failure to follow these instructions can result in death, injury or property damage.

WARNING

Cut/Pinch Hazard

Wear protective gear during installation, operation and service.

Edges are sharp.

Failure to follow these instructions can result in injury.

To ensure your safety, and comply with the terms of the warranty, all units must be installed in accordance with these instructions.

The gas or the electrical supply lines must not be used to support the heater.

Do not locate the gas or electrical supply lines directly over the path of the flue products from the heater.

The heater must be installed in a location that it is readily accessible for servicing.

The heaters must be installed with clearances to combustibles as indicated on the rating plate and in this manual.

The minimum and maximum gas inlet pressures must be maintained as indicated on the rating plate. Typical installation configurations are shown on Page 12, Figure 17.

NOTE: Some models may receive S-hooks (P/N 91907302) or spring hooks (P/N 91903300), rather than bow shackles.

11 of 73