Roberts Gorden HE40ST, HE20ST, HE50DL, HE45UT Reflector Support Strap 03050000 Screw #8 x 3/4

BLACKHEAT® HE INSTALLATION OPERATION AND SERVICE MANUAL

Step 7.8.1 Reflector, U-clip and Reflector Support Installation

The pictorial drawings of the heater construction in Section 6 are schematic only and provide a general guideline of where hangers, reflector supports and u-clips are to be installed.

To ensure proper expansion and contraction movement of the reflectors, a combination of u-clips and reflector

supports are used. The positioning of reflector supports and u-clips depend on the individual installation. Use either pop rivets or sheet metal screws instead of u-clips when installing end caps and joint pieces in areas where impact and high wind may be a factor. The following rules must be observed:

1.The first reflector after the burner must be affixed in the middle of the reflector with a reflector support and tight screws.

End

Reflector

U-clips

Overlap must
be a minimum	160 mm
of 160 mm

Tight

Sheet Metal

Screw

Wire Form

Reflector Support

Strap

Option B

Slip Overlap Reflector

Reflector

Support

2.The overlap at the first and second reflector is a slip overlap. Thereafter, every third reflector joint is a slip overlap. A slip overlap is achieved by either: a.) both reflectors lay inside a hanger.

(no reflector support needed). b.) using a reflector support with

loose screws at the reflector overlap.

Loose screws loosened 2 mm to allow slippage.

Option A

Slip Overlap

3.The remaining reflector overlaps require a non-slip overlap connection. To affix the reflectors together in a non-slip overlap either:

a.) use reflector support and tight screws. b.) if both reflectors lay inside a hanger,

u-clips or sheet metal screws may be used.

This section of three reflectors joined together must be affixed to the tube with at least one reflector support with tight screws.

Option B

Non-Slip Overlap

Option A

Non-Slip Overlap

Reflector

Tight

Screws

Description	Part Number
Reflector Support Package	03050010
Wire Form	91908004
Reflector Support Strap	03050000
Screw #8 x 3/4	94320812
U-clip Package	91107720
Reflector End Cap	027508XX

U-clip (2 clips per

non-slip overlap inside a hanger)

34 of 73