102
Insert Effect Parameter Functions
Rev0.10
A sound with a subtly shifted pitch is added to the direct
sound, making the final output sound thicker and broader.
Best results will be achieved when stereo recording.
* This effect can be used when the MODULATION “Type”
parameter is set to “CHORUS.”
On/Off OFF, ON
This parameter turns the chorus effect on/off.
Rate 0 – 100
Adjusts the rate of the Chorus effect.
Depth 0 – 100
Adjusts the depth of the Chorus effect.
Pre Dly 0.5 – 50.0 ms
Adjusts the time needed for the effect sound to be output
after the direct sound has been output.
E.Level 0 – 100
Adjusts the volume of the effect sound.
This corrects differences in input to create a steadier, more
even volume balance. This is used to extend the sustain of
input sounds and, conversely, to shorten sustain and
emphasize the attack portion of sounds.
Another use of compression is as a “limiter,” which
prevents distortion by suppressing only volume peaks.
On/Off OFF, ON
This parameter turns the compressor effect on/off.
Sustain 0 – 100
This adjusts the depth of the effect. Higher settings values
result in longer sustain times. Set this to a lower value when
using compression for the limiter effect.
Attack 0 – 100
Adjusts the strength of the attack. Larger values will result
in a sharper attack, creating a more clearly defined sound.
Level 0 – 100
Adjusts the volume.
The compressor corrects differences in input to create a
steadier, more even volume balance. It is used to extend the
sustain of input sounds and, conversely, to shorten sustain
and emphasize the attack portion of sounds.
The limiter is an effect that prevents distortion by
suppressing input signals that exceed a set value
(threshold). You can get the same effect achieved with the
compressor by setting the threshold at a low value.
The BR-600 uses COSM technology to model four types of
compressor/limiter in which the compressor and limiter
functions are combined.
On/Off OFF, ON
Sets the compressor/limiter to ON or OFF.
Type
Selects the compressor/limiter type.
BOSS-Cmp :
Models the BOSS CS-3 compact effects processor.
D-Comp :
Models the MXR dyna comp.
Rack160 :
Models the dbx 160.
VtgRack :
Models the UREI 1178.
Attack (with BOSS-Cmp, D-Comp) 0 – 100
Adjusts the strength of the picking attack when the strings
are played. Larger values will result in a sharper attack,
creating a more clearly defined sound.
Sustain (with BOSS-Cmp, D-Comp) 0 – 100
Boosts low-level signals, adjusting the time over which
sounds are sustained. Higher values deepen the effect,
resulting in a longer sustain.
Threshold (with Rack160) 0 – 100
Adjust this as appropriate for the input signal from your
bass. The compression effect is applied to input above the
level set here. The smaller the value set here, the lower the
level at which the limiter effect kicks in.
Input (with VtgRack) 0 – 100
Controls the input level. Increasing the value will produce a
deeper effect.
Ratio (with Rack160) 1:1 – 20:1, INF:1
(with VtgRack) 4:1 – 20:1
Adjusts the limiter compression ratio. Higher ratio create a
stronger compression effect.
ChorusCompressor

COSM Comp (compressor)/Limiter

BR600_e2 102ページ ２００６年４月１７日　月曜日　午前９時３分