Rev0.10

31

Quick Start

Turning On / Off the BR-600

Be sure to use the following steps to turn on the power.
Making a mistake in this procedure may result in
malfunction or cause damage to your speakers.

1

Before you turn the power on, make sure of the
following points.

■

Are all external devices connected properly?

■

Is the volume on the BR-600 and all other devices
completely lowered?

■

Is the memory card inserted?

2

Lower the MASTER fader on the BR-600.

fig.00-140

3

Turn on the devices connected to the input jacks (i.e.,
GUITAR/BASS, MIC 1, MIC 2, or LINE IN).

4

Turn on the POWER switch located on the rear panel.

fig.00-150

5

Turn on the device connected to the output jack (i.e.,
LINE OUT).

1

Make sure that playback of the song is stopped.

2

Turn off the power to each device in the reverse order
used for powering up.

3

Confirm that "Keep power on!" is not indicated in the
display.

4

Turn the BR-600’s POWER switch off.

Turning On the Power

Turning Off the Power

• Always make sure that the recorder is stopped
before turning off the power to the BR-600.
Turning off the power while recording or playback
is in progress may result in the deletion of (song)
data, mixer settings, and/or effect patch data.
•If you are using the AC adaptor, make sure that the
AC adaptor does not become unplugged during
operation.
If the AC adaptor becomes unplugged accidentally,
the recorded data may become damaged.
• Turning off the power while the message "Keep
power on!" is displayed may result in corruption of
the data. Be careful not to turn off the power while
this message is displayed.
• This unit is equipped with a protection circuit. A
brief interval (a few seconds) after power up is
required before the unit will operate normally.
•The BR-600 is shipped with a memory card already
inserted in the slot.
•Always make sure to have the volume level turned
down before switching on power. Even with the
volume all the way down, you may still hear some
sound when the power is switched on, but this is
normal, and does not indicate a malfunction.
BR600_e2 31 ページ ２００６年４月１７日　月曜日　午前９時３分