129
Fixing the Pitch of Vocals (Pitch Correction)
Rev0.10
Section 3
6
Use [CURSOR] to move the cursor to “Smth” and
specify the correction speed.
Smth (Smooth) -100 – +100
The value set here is added to the value for the
“Smooth” patch parameter (p. 127).
When set to 0, the correction proceeds at the rate set in
the patch’s “Smooth” parameter.
The correction is performed more rapidly the lower the
value is compared to the value set for the patch, while
the correction is carried out more smoothly as the
value increases relative to the patch’s value.
* Set the value so that the sum of the values is in a range from
0 to 100. The pitch correction produces no effect when the
value is set below 0 or over 100.
7
Use [CURSOR] to move the cursor to “INSERT” and
press [ENTER].
Another new correction event is inserted.
8
Use [CURSOR] to move the cursor to “TIME” and
specify the time at which you want the correction to
end with the TIME/VALUE dial.
fig.03-720
9
Use [CURSOR] to move the cursor to “NOTE” and
specify “OFF.”
10
Have the Recorder play the song from the beginning.
The correction is first applied at the point in the song
specified in Step 4, with the correction ending at the
point specified in Step 8.
11
To delete the currently selected correction event, use
[CURSOR] to move the cursor to “ERASE” and press
[ENTER].
The correction event is deleted.
12
Repeat Steps 3–11 as needed to specify the edited
range.
13
After you have completed entering the settings, press
[EXIT] repeatedly to return to the Play screen.
Time
Smth
(Correction Speed)
NOTE
• You cannot delete the correction event at the
beginning of the song. If this correction event is
unneeded, rather than deleting it, just set the
function to “OFF.”
• You can only save a Correction Event Map to a
single song. Even if you switch the patch with the
pitch correction, the Correction Event Map
remains unchanged.
BR600_e2 129ページ ２００６年４月１７日　月曜日　午前９時３分