Roland BR-600 Re-recording Only a Mistake (Punch-in/out)

60
Rev0.10
Re-recording Only a Mistake (Punch-in/out)
You may occasionally make a mistake while recording, or
the performance may not turn out as you expect. In this
case, you can punch in/out to re-record only the portion
that is mistaken.
Changing to recording during the playback of a song is
referred to as punching in , and changing from recording to
playback is referred to as punching out .
Therefore, punch in at the location where you want to begin
the re-recording, and punch out at the location where you
want the re-recording to end.
fig.01-170
With your BR-600, you can choose from manual or
automatic punching in/out.
You can use the [REC] or a foot switch to punch in or out.
* When using manual punch-in/out, you need to allow for an
interval of at least one second between the punch-in and
punch-out points.
As an example of use, the explanation below assumes you
are manually punching in and out to re-record a portion of
track 1, which is a track to which you have already
recorded.
1
Press REC TRACK [1].
REC TRACK [1] lights alternately in orange and green.
2
Place the fader for track 1 at the location shown below.
fig.01-180
3
Start playback and adjust the volume of the input
source using the REC LEVEL dial.
Listen to the track you will be re-recording and the
input source and adjust the volume of the input source
using the REC LEVEL dial so that it is the same level
as the track.
4
Move to a position before where you want to start
re-recording and press [PLAY] to start playback.
5
Press [REC] to punch in at the location where you
want to start recording.
The BR-600 starts recording.
6
To punch out, press [REC] (or [PLAY]) again.
Each time you press [REC], you punch in and punch
out, so if there is another location that you want to
redo, then you can punch in again at that location
using the same procedure.
7
Press [STOP] to stop recording.
* During updating, “Keep power on!” appears in the upper
line of the display, while the lower line shows what is being
processed.
8
Listen to the re-recorded results.
Return the song to a point earlier than you re-recorded,
and play it back.
Adjust the volume of track 1 using the TRACK fader.
Manually Punching In/Out
■
Manually punching in and
out using [REC]
Time
Punch-In Stop
Start
[PLAY][
REC][ REC][ STOP]
Punch-Out
Playback PlaybackRecording
• You can use the Undo function (p. 64) to revert to
the condition before re-recording.
• The data prior to punch-in/out will remain on the
memory card without being erased. If this data is
no longer needed, in order to use the memory card
effectively, use the song optimize function (p. 87)
to delete unneeded data from the memory card.
BR600_e2 60 ページ ２００６年４月１７日 月曜日 午前９時３分