Roland BR-600 , Erasing the repeated

83
Editing the Performance on a Track (Track Edit)
Rev0.10
Section 2
3
Press CURSOR [ ] [ ] to move the cursor to
“ERS,” and press [ENTER].
fig.02-520
4
Turn the TIME/VALUE dial to select “TME/MES”
and press [ENTER].
fig.02-530
5
Use CURSOR [ ] [ ] and the TIME/VALUE dial
to select the track/V-Track to erase from.
6
Press [ENTER].
fig.02-540
7
Use [CURSOR] and the TIME/VALUE dial to specify
the beginning of the portion “S” (Start) of data you
want to erase.
8
Press [ENTER].
fig.02-348d4
9
Use [CURSOR] and the TIME/VALUE dial to specify the
ending of the portion “E” (End) of data you want to erase.
10
When you are ready to execute the erasure, press [ENTER].
The display will ask “Are you sure?,” so that you can
confirm the operation.
11
Press [ENTER].
The erasure is executed.
12
Press [UTILITY] (or press [EXIT] repeatedly) to
return to the Play screen.
* During updating, “Keep power on!” appears in the upper
line of the display, while the lower line shows what is being
processed.
Perform the procedure given below to erase the portion
from the repeat start (A) to the repeat end (B).
fig.02-460
1
Confirm that [PAD] is not lit, then press [UTILITY].
2
Press CURSOR [ ] [ ] to move the cursor to
“TRK,” and press [ENTER].
fig.02-470
■
Erasing the repeated
portion (AB)
After specifying the time in the procedure above, a “+”
may appear to show that there is a discrepancy between
the actual current position and the position displayed. If
you specify the locations using measures, specify the
locations at each screen using the TIME/VALUE dial to
eliminate the discrepancy.
You can also enter the time using [LOCATOR], [ZERO], [STOP]
+ [REW], [STOP] + [FF], and AUTO PUNCH [IN/OUT].
Repeat
Start (A)
Repeat
End (B)
Time
BR600_e2 83 ページ ２００６年４月１７日 月曜日 午前９時３分