Advanced Uses
Using the SI-24’s DIGITAL IN
Here’s how you can connect the
The
■Connect Your Digital Device
1.Use a digital audio cable (coaxial) to connect the digital output jack of your digital audio device to the
2.Set the sampling frequency of your digital audio device to match the sampling frequency used by SONAR.
■Make Settings on the SI-24 and in SONAR
1.Setting the Sampling Rate and the File Bit Depth in the SONAR.
•Choose
•Click the General tab.
•Under Default Settings for New Projects, select a Sampling Rate.
•Click OK.
2.Press the
•If using the
■Change the RPC-1 Settings
1.Access the
For details on operation, refer to
Patchbay Settings)” (p. 14).
2.Select the “Hardware Settings” tab.
3.Change the “Master Clock” setting from “Int. Clock” (Internal Clock) to “Ext. Clock” (External Clock).
When you finish using the DIGITAL IN connection, change this setting back to “Int. Clock.” If you leave this setting at “Ext. Clock” even after the device generating the clock signal has been disconnected from the
4.Select the same frequency as the output of the digital audio device.
5.Click [Done] to close the RPC-1 Control Panel.
29
