Operation
To adjust the horizontal and vertical position of the OSD, select OSD Position and press ENTER. Then, press the 
or 
button to select Horizontal or Vertical and use the
or 
button to adjust.
PC & HD Adjust: Use the settings in the PC & HD Adjust menu to
•Auto: Adjusts the phase, frequency and position automatically.
•Freq. Adjusts the frequency of the signal.
•Phase: Adjust the phase if the image (usually from an RGB source) shows shimmer or “noise.” Pixel phase adjusts the phase of the pixel sampling clock relative to the incoming signal. The effect of this control is similar to that of a tracking control on a VCR.
For best results, use a good test pattern such as a smooth gray consisting of a clear pattern of black and white pixels, or a similar “half on, half off” graphic image. (You may find that you can stabilize the image at more than one point. Use either setting in this case.)
•H. Pos.: Adjusts the horizontal position of the image.
•V. Pos.: Adjusts the vertical position of the image.
Note | To adjust the image position with a 480i source, use the Image |
Shift controls in the Set Up menu (see page 43). |
PIP/PBP Set Up: Select PIP/PBP Set Up from the Option menu to change the PIP/PBP settings.
•PIP/PBP Enable: Press the 
or 
button to select PIP/PBP Enable, then press ENTER. Press the 
or 
button to select Off or On, then press ENTER.
•PIP Set Up: Press the 
or 
button to select PIP Set Up, then press ENTER. Press the 
or 
button to select PIP Off, Graphic in Video or Video in Graphic, then press
ENTER.
•PBP Set Up: Press the 
or 
button arrows to select PBP Set Up, then press ENTER. Press the 
or 
button to select PBP Off, Graphic by Video or Video by Graphic, then press ENTER.
DNR: Use the 
or 
button to adjust the Digital Noise Reduction (DNR). DNR is useful for clearing up noisy images from interlaced SD sources. Adjust as desired, keeping in mind that reducing noise (which reduces high frequencies) may also soften the image.
Runco | 41 |
