Runco CL-610 manual Height Y Adjustment, Adjusting the Anamorphic Lens

Installation

Height (Y) Adjustment:

1.Project a white field on the screen.

2.Ensure that the four Y-Adjustment Screws are loose enough to allow movement of the lens assembly.

3.Slowly move the anamorphic lens into place so that there are no shadows on the top or bottom of the screen:

Too Low

Correct position

Too High

4.When the height is properly set, tighten the Y-Adjustment Screws to secure the lens in place.

Adjusting the Pitch (Angle): Next, angle the lens to even out any top-to-bottom pincushion distortion. To do this, loosen the Pitch Adjustment Screws on either side of the lens to allow it to pivot freely. Then, adjust the anamorphic lens angle so that the projected image is rectangular:

Correct Lens Angle

Incorrect Lens Angle

The anamorphic lens will almost always be angled with respect to the projector; this is normal.

Once the proper lens angle has been set, firmly tighten the Pitch Adjustment Screws to secure the lens in place.

Adjusting the Anamorphic Lens

Runco CL-610 Series Owner’s Operating Manual 27