Runco runco super hdtv dtv video projector Input selection, General Access Menu Items Source

Controlling

Input selection.

GENERAL ACCESS MENU ITEMS

SOURCE Projector input

1Comp. Video

2S - Video

3RGBS of RGsB

4RGB3S or RG3sB

5(R - Y) Y (B - Y)3S or (R - Y)Ys(B - Y)

6(R - Y) Y (B - Y)3S or (R - Y)Y3s(B - Y)

Choose from table above. Push the control disk up or down to move the cursor up and down, push the control disk to the left or to the right to move the cursor to the left and to the right.

Press ENTER to confirm your selection.

When a valid and available source is selected, there will be infor- mation displayed on the screen about that source. This informa- tion includes :

-Source number

-Horizontal frequency

-Vertical frequency

Source 2

Fh = 15.6 kHz

Fv = 50 Hz

When the entry is a non valid source number, a warning appears on the screen : ‘input not available’.

Two possible ways of selecting an input :

a)Display General access menu with RCU by pressing ADJ but- ton. This brings up a secondary general access menu. Choose source selection and highlight desired source.

b)With the local keypad :

Press first the ADJUST key to display the General access menu. Use the control disk to highlight the desired source number.

Warning input not available

ADJUSTEXIT

STANDBY ENTER

	GENERAL ACCESS
		SHARPNESS
		TINT
5	6	COLOR
3	4	BRIGHTNESS
1	2	CONTRAST
Enter ADJUST
	Select with	,
		or
	then <ENTER>.

<EXIT> to return

When a valid source number is selected, the projector will display this source or it will wait on the selected source number until the source becomes available. A message ‘source not available’ will be displayed for a short time.

Warning source not available

General Access From Local Keypad

GENERAL ACCESS

SELECT AN OPTION

FROM BELOW:

SOURCE SELECTION

EYE-Q

ADJUSTMENT MODE

Select with

or

then <ENTER>

<EXIT> to return

GENERAL ACCESS

SELECT AN OPTION

FROM BELOW:

SOURCE SELECTION

EYE-Q

ADJUSTMENT MODE

Select with

or

then <ENTER>

<EXIT> to return

4-3