Runco runco super hdtv dtv video projector, dtv-992/992 ultra Location and Function of Controls

2 LOCATION AND FUNCTION OF CONTROLS

This device complies with part 15 of the FCC rules. Operation is subject to following two conditions (1). This device may not cause harmful inter- ference, and (2) this device must accept any interference received including interference that may cause undesired operation.

Comm Port	Port 3	R	G	B Comp/ VSYNC	VIDEO	Green=Oper.
Off On				HSYNC		Red=Stby
Power/Mains

1 2 3 4 5 6 7 8 9 10

REAR PANEL TERMINOLOGY

1Power Switch: press the switch to turn the projector ON.

Depending on the hardware set-up of the projector during installation, the projector switches to ‘Standby’ or to ‘Opera- tional’ mode. If in standby, the standby LED lights up.

2AC Power Input

3Communication Port

•allows connection of a remote IR receiver unit to the projector.

4Port 3

RGB Analog Input (9 pin female sub D connector). Allows a character generator, microcomputer, etc. having analog RGB outputs to be connected to the projector.

5Port 4/5: RGB-S Input (5x BNC connector):

RGB-S input: allows a character generator, microcomputer, video camera, etc. having analog RGB Output to be con- nected to the projector.

Line inputs

– signals RED-GREEN-BLUE

– COMPOSITE sync. signal

– Tri level sync. signal (option>)

6S-VIDEO Input: (Not Active)

775 ohm Termination Switch for S-Video signals

8VIDEO Input: (Not Active)

975 ohm Termination Switch for Video signals: (Not Active)

10Projector Pilot Lamp: indicates the Status of the projector.

–unlit: mains (power) switch is not pressed.

–lit: mains (power) switch is pressed and the indicated color shows the projector mode: Green color : operational mode of the projector. Red color: standby mode of the projector.

			NS	8m
			LE	m
RS232 IN	RS232 OUT	IR REMOTE	V
			T
			T	m
			V
				8m
			LE NS
IN RS232	OUT RS232	IR REMOTE

11 12 13 14 15

FRONT PANEL TERMINOLOGY

11RS 232 Input Port

Connection between the DTV-992 / 992 ULTRA and an IBM PC (or compatible) Or MAC (RS422) for remote computer control and data communication.

12RS 232 Output Port

RS232 Input Port allows a communication link for PC 0r MAC to the next projector in a series of projector.

13IR Sensor

receiver for control signals transmitted from the RCU.

14IR Remote

Connector for remote input for hard wired remote Control.

15EYE-Q Camera

2-1