Runco dtv-992/992 ultra manual Identification, Copy a block, Copy a Block

Service Mode

Identification

Highlight ‘Identification’ with the control disc and press ENTER.

ENTER will start the selected item.

EXIT returns to the Service mode menu.

The ‘Identification’ screen gives information concerning :

-Projector address. To change the address of your projector, contact a qualified service technician.

-Software version.

-Configuration.

Possible installations :

*Front-ceiling

*Front-table

*Rear-ceiling

*Rear-table

-Baud rate PC : transfer speed for communication with an IBM PC (or compatible) or MAC. The baud rate of the projector must be the same as the baud rate of the connected computer. When there is a differ- ence, contact a qualified service technician to make the appropriate changes.

-Text ON/OFF

Indicates in operational mode if the bar scale and number indicator will be displayed and if warnings and failures will be displayed.

ON : displayed

OFF : not displayed

The status can be changed by pressing the ‘TEXT’ key once on the RCU.

-Serial no. : indicates the fabrication number of the projector. This number can be useful when calling for technical assistance.

Copy a block

The copy a block function copies the settings of a selected block into the active block.

Highlight copy a block with the control disc and press ENTER.

ENTER will select the highlighted item.

EXIT returns to the Path Selection main menu.

ADJUST returns to the Operational mode.

To copy the settings of a closed block to the block you are working on (active block), use the control disc to select a block.

All existing settings will be overwritten with the new settings.

Press ENTER to copy the selected block. A confirmation screen will be displayed.

If you are certain you wish to copy the contents of the selected block into the active block, press ENTER.

ENTER displays a confirmation screen.

EXIT returns to the Service Mode main menu.

EXIT cancels the copy procedure and returns without copying the block.

PROJECTOR SET-UP

IDENTIFICATION

TOTAL RUN TIME

CHANGE PASSWORD

CHANGE LANGUAGE

CHANGE PROJECTOR ADDRESS

CHANGE BAUDRATE

POWER UP MODE: operating

RUNCO

DTV - 992

Proj. address : 001

Soft. Version : 6.00

Config. :Ceiling

Front

Baudrate PC : 9600

Text : ON

Serial No. : 103589552

MEMORY MANAGEMENT

COPY A BLOCK

DELETE A BLOCK

DELETE ALL BLOCKS

ALL SETTINGS TO MIDPOS

		COPY MODE
Nr.	Src	Fh	Fv	inp	conf
1	1	15.6 50		video	FC
			COPY BLOCK
	All settings
	in current block
	will be overwritten !

Select with or then <ENTER> <EXIT> to return.

7-2