Runco runco super hdtv dtv video projector, dtv-992/992 ultra manual Start up with full white image

Connections

When starting up the projector, with the power switch or via the stand-by key, the projector can start up in two ways if the “CRT run in” cycle option is switched OFF.

-full white image (projector warm up) or

-immediately image display.

The way of starting up can be set in the service mode.

Start up with full white image.

The next menu will be displayed for 30 seconds.

a. Start up with warm up period.

If no action is taken, a white image will be displayed for 20 min- utes.

This white image will be shifted on the faceplate of the CRT to avoid burn in. During this warm up period, it is possible to interrupt this white image projection by pressing the EXIT key. The previous menu will be repeated for another 30 seconds but the remaining time will be indicated.

If EXIT is pressed, the remaining warm up period will be shipped.

During the warm up period, every 30 seconds a text box with the remaining time will be displayed on the screen for 2 seconds. This text box will be displayed every time on another place.

If another key, different from EXIT, is pressed, a text box with fol- lowing text will be displayed:

Please use <EXIT> to leave this procedure.

b. Start up without warm up period.

If the EXIT key is pressed, the warm up period will be skipped and the projector is immediately ready for use.

Warning : skipping this warm up procedure can reduce the initial picture quality of the projected image.

Signal Input Connection to the Projector:

-Composite Video

-S-Video

-RGBS or RGsB

-RGB3S or RG3sB (option)

PROJECTOR WARM UP

A FULL WHITE PATTERN WILL BE GENERATED FOR 20 MINUTES

FOR IMMEDIATE USE OF THE PROJECTOR, PRESS <EXIT>

WARNING: SKIPPING THIS PROCEDURE CAN REDUCE THE INITIAL PICTURE QUALITY OF THE PROJECTED IMAGE.

THIS OPTION CAN BE

DISABLED IN THE SERVICE

MENU

REMAINING PROJECTOR WARM UP TIME

18.5 MIN

PLEASE USE

<EXIT> TO

LEAVE THIS

PROCEDURE

This device complies with part 15 of the FCC rules. Operation is subject to following two conditions (1). This device may not cause harmful inter- ference, and (2) this device must accept any interference received including interference that may cause undesired operation.

Comm Port	Port 3	R	G	B Comp/ VSYNC	VIDEO	Green=Oper.
Off On				HSYNC		Red=Stby
Power/Mains

Port No.		Projector Input	Press Digit Button
1		Not Used	Not Used
2		Not Used	Not Used
3		RGB2	3
4/5		RGB2	4 or 5
4/5		Component Video3	6
	4/5	RGB with Tri-Level Sync4	7
	4/5	Component Video
		with Tri-Level Sync5	8

3 4 5 2 1

1Not Used

2Not Used

3Input signal : R-Y, Y and B-Y with separate composite sync or with separate Hor and Vert. sync or with composite sync on Y.

4Input signal : R, G and B with separate Tri level sync or with Tri-level sync on green.

5Input signal : R-Y, Y and B-Y with separate Tri level sync or with composite Tri-level sync.

*Video or S-Video : switchable in the Picture Tuning menu.

Only available when the optional Tri-level sync module is installed.

3-2