OPERATION
FILLING THE FUEL TANK
See Figure 2.
nClean the surface around the fuel cap to prevent contamination.
nLoosen the fuel cap slowly.
nCarefully pour the fuel mixture into the tank. Avoid spillage.
nPriortoreplacingthefuelcap,cleanandinspectthe
nImmediately replace the fuel cap and hand tighten. Wipe up any fuel spillage.
NOTE: It is normal for the engine to emit smoke during and after the first use.
ADDING BAR AND CHAIN LUBRICANT
See Figure 3.
Use RYOBI Bar and Chain Lubricant. It is designed for chains and chain oilers, and is formulated to perform over a wide temperature range with no dilu- tion required. Chain saw should use approximately one tank of lubricant per tank of fuel.
NOTE: Do not use dirty, used, or otherwise con- taminated lubricants. Damage may occur to the oil pump, bar, or chain.
nCarefully pour the bar and chain lubricant into the oil tank.
nFill the oil tank every time you fuel the engine.
Fig. 2
Fig. 3
Page 13 — English
