BAR AND CHAIN COMBINATIONS
Chain specifications: 0.0325 pitch, .05 in. chain gauge |
|
| |
Length of Bar | Guide Bar Part Number | Chain Part Number | Drive Links |
20 in. | 310629001 | 900920027 | 78 link |
18 in. | 310628001 | 901430001 | 72 link |
TROUBLESHOOTING
Problem | Possible Cause | Solution |
| |
Engine will not | No spark. | Clean or replace spark plug. Reset spark plug gap. Refer |
| |
start. [Make sure |
| to Spark Plug Replacement earlier in this manual. |
| |
ignition switch is in | Engine is flooded. | With the ignition switch OFF, remove spark plug. Move |
| |
the RUN ( l ) posi- |
| |||
tion.] |
|
| choke lever to RUN position (pushed in completely) and |
|
|
| pull starter cord 15 to 20 times. This will clear excess |
| |
|
|
|
| |
|
|
| fuel from engine. Clean and reinstall spark plug. Set igni- |
|
|
|
| tion switch to RUN ( l ) position. Push and fully release |
|
|
|
| primer bulb 7 times. Pull starter three times with choke |
|
|
|
| lever at RUN. If engine does not start, move choke lever |
|
|
|
| to FULL CHOKE and repeat normal starting procedure. |
|
|
|
| If engine still fails to start, repeat procedure with a new |
|
|
|
| spark plug. |
|
|
|
|
| |
Engine starts but | Carburetor requires | Contact an authorized service center for carburetor |
| |
will not accelerate | “L” (Low Jet) | adjustment. |
| |
properly. | adjustment. |
|
| |
|
|
|
| |
Engine starts, then | Carburetor requires | Contact an authorized service center for carburetor |
| |
dies. |
| “L” (Low Jet) | adjustment. |
|
|
| adjustment. |
|
|
|
|
|
| |
Engine starts but | Carburetor requires | Contact an authorized service center for carburetor |
| |
will not run proper- | “H” (High Jet) | adjustment. |
| |
ly at high speed. | adjustment. |
|
| |
|
|
|
| |
Engine does not | Lubricant/fuel | Use fresh fuel and the correct |
| |
reach | full speed | mixture incorrect. | ratio. |
|
and/or | emits ex- | Air filter is dirty. | Clean air filter. Refer to Cleaning the Air Filter in the |
|
cessive smoke. |
| Maintenance section of this manual. |
| |
|
|
|
| |
|
| Spark arrestor | Clean spark arrestor screen. Refer to Inspecting/Clean- |
|
|
| screen is dirty. | ing the Spark Arrestor Screen in the Maintenance sec- |
|
|
|
| tion of this manual. |
|
|
| Carburetor requires | Contact an authorized service center for carburetor |
|
|
| “H” (High Jet) | adjustment. |
|
|
| adjustment. |
|
|
|
|
|
|
|
Page 38 — English