Electrical work

Electrical wiring

ffConnect it to the terminal board N and L for power cable to the outdoor unit. In so doing, peel off the end of the power cord by about 5mm, and press the cord to the ring terminal for hooking.

-- Make sure to install exclusive power supply. (If you use multiple connecting, there is a risk of electric shock or fire.) -- If the outdoor power supply has been selected, install circuit breaker(ELCB). (Purchase separately)

-- Make sure to connect earth wire.

-- Make sure that the clamping force of the screw (on the terminal) is tightened firmly within the range of rated tightening torque.

-- The appliance shall be installed in accordance with national wiring regulations for installation (SASO 2007:2002). -- Disconnection means must be incorporated in the fixed wiring in accordance with the wiring rules.

Connecting the power terminal

ffConnect the cables to the terminal board using the compressed ring terminal.

ffUse rated cables only and make sure to fix them without applying any external force to the terminal. ffConnect the cables with driver and wrench that can apply the rated torque to the screws.

ffMake sure that appropriate tightening torque is applied for cable connection. If the terminal is loose, arc heat may occur and cause fire and if the terminal is connected too firmly, terminal may get damaged.

Screw

Tightening torque (kgf·cm)

 

 

 

M3

5.0

~ 7.5

 

 

M3.5

8.0 ~ 12.0

 

 

 

M4

12.0

~ 18.0

 

 

 

M5

20.0

~ 30.0

 

 

 

M6

25.0

~ 37.5

 

 

 

38

PAC MIRAGE HPCO-AR-PH_IBIM_05321A-01_EN.indd 38

2015-03-03 오후 4:39:44