7
The mains lead is attached to the right side of your COMBIVISION.
☛If you have purchased this set in the United Kingdom,
refer to page 46 for further instructions on plug wiring.
1Plug the mains lead into an appropriate wall socket and press the Master
Switch (I ) on the front panel.
Result:The set is placed in Standby mode and the Standby indicator
lights up on the front panel.
2To switch your set on, press POWER ( ).
Result:If stations have already been stored, the station (or AV input)
that you were watching prior to switching off the unit is
selected automatically. You can now use the remote control,
as required.
3To switch the set off, press POWER ( ) again.
➢If you wish to switch the COMBI VISION off completely,
disconnect it from the wall socket or press the Master
Switch. This is particularly recommended when you will
not be using the set for a long period of time and you
have not set the VCR unit to record a programme
automatically.
Switching Your Combi Vision On and Off
You must insert or replace the batteries in the remote control when
you:
◆Purchase the television
◆Find that the remote control is no longer operating
correctly
1Remove the cover on the rear of the remote control by pressing the symbol
downwards and then pulling firmly to remove it.
2Insert two R03, UM4, “AAA” 1.5V or equivalent batteries taking care to
respect the polarities:
◆+ on the battery against + on the remote control
◆- on the battery against - on the remote control
3Replace the cover by aligning it with the base of the remote control and
pressing it back into place.
➢Do not mix battery types, i.e. alkaline and monganese.
Inserting the Batteries in the Remote Control
INPUT
02255A_eng1_mono 6/29/04 10:42 AM Page 7