•System requirements mentioned above are recommendations. Even on a system that satisfies the requirements operation is not ensured depending on the system.
•On a Macintosh computer, you can also transfer data by connecting the USB cable, but the provided CyberLink MediaShow4 is not
•This memory camcorder can be used only as a removable storage device for the computers with Macintosh (OS version 10.3 or later) and Windows 2000.
•On a slower PC than recommended, movie playback may skip frames or operate unexpectedly.
•If your OS is Windows XP/Vista, log in as the Administrator (administrator of the PC) (or a user with the equivalent privileges) to install the software.
•Check out the storage media of the memory camcorder before connecting USB cable.
If no memory card or an unformatted memory card is inserted, the PC will not recognize your memory camcorder as a removable disk.
•If you disconnect the USB cable from the PC or the memory camcorder during the data transfer, the data transfer will stop and the data may be damaged.
•If you connect the USB cable to a PC using a USB HUB or with other devices at the same time, it may cause conflict and may not work properly. If this occurs, remove all other USB devices and try the connection again.
•Intel® Pentium III® or Pentium ®4 is a trademark of the Intel Corporation.
•Windows® is a registered trademark of the Microsoft® Corporation.
•All other brands and names are property of their respective owners.
•CyberLink MediaShow4 is optimized for Intel Core 2 Duo processors and CPUs with MMX, SSE, SSE2, 3DNow!, and Intel HyperThreading technology.
•DirectX is necessary so that CyberLink MediaShow4 works properly and it is automatically installed during CyberLink MediaShow4 installation.
•We recommend using the AC power adaptor as the power supply instead of the battery pack.
