Installing the driver locally

A locally connected machine is a machine directly attached to your computer using the cable. If your machine is attached to a network, skip the following steps below and go on to installing a network connected machine’s driver (see "Installing driver over the network" on page 144).

• If you are a Macintosh or Linux operating systems user, refer to the "Installation for Macintosh" on page 134 or "Installation for Linux" on page 136.

The installation window in this User’s Guide may differ depending on the machine and interface in use.

Selecting Custom Installation allows you to choose which programs to install.

Only use a USB cable no longer than 3 meters (118 inches).

Windows

1Make sure that the machine is connected to your computer and powered on.

If the “Found New Hardware Wizard” appears during the installation procedure, click Cancel to close the window.

2Insert the supplied software CD into your CD-ROM drive.

If the installation window does not appear, click Start > All programs > Accessories > Run.

X:\Setup.exe replacing “X” with the letter, which represents your CD- ROM drive and click OK.

3Select Install Now.

4Read the License Agreement, and select I accept the terms of the License Agreement. Then, click Next.

5Follow the instructions in the installation window.

1. Introduction 30

Page 30
Image 30
Samsung SCX3405FWXAC manual Installing the driver locally, Windows, Follow the instructions in the installation window