Samsung SHR-4081P manual 6TroubleshootingFAQ

6Troubleshooting(FAQ)

1.The system power is dead and LED in front of the system does not operate at all.

-Please check the power connection.

-Check the power voltage.

-If all your efforts like above end up with nothing, check or exchange the power supply.

2.Video data remains in the system but some channels displays no video data but turns all blue.

-Check the image of the camera connected to the system. Improper input of camera input may cause this symptom.

-Check the camera power supply.

-Sometimes, you see this symptom when the video data is connected with multi- systems and the video signal from the video data distributor in use feels weak. If it’s the case, you shall connect the camera images with SHR-4081N/P DVR directly to check or improve such a symptom.

3.The REC button in front has no effect on turning on REC LED or recording process.

-Please check the HDD space.

-Please check the Record Mode setup in MENU. It should be On.

4.All the front LEDs are in operation but the monitor remains black.

-Video out may come out differently with the connected monitor. In short, Video Out is set to Composite Output but connected to VGA Input Monitor or vice versa. Press the "MODE" button and "0" button of front left at the same time for 5 seconds, and press them to the time that the LED is On in sequence to change the Video Out mode.

5.The front LED blinks and the logo screen repeatedly appears.

-This symptom may be resulted from failure of HDD connection inside SHR-4081N/P DVR. Take off the cover and check HDD connection status. If HDD connection has no problem, please consult with the shop where you bought SHR-4081N/P DVR.

6.You cannot enter MENU by forgotten password.

-If you forget the password, you shall reset SHR-4081N/P DVR to the values set at the factory. Keep pressing both the "MODE" button and the "5" button on the left for 5 seconds until LED lights on in the order of 1➝ 2➝ 3➝ 4➝ 5. The pass- word default is "4321".

12-10