1_SMO-210TP_ENG 5/30/03 2:56 PM Page e-11

I.MENU

Display the Setup menu on the screen. Press it again to exit the Setup menu.

J.MULTISCREEN

Switches to the split screen view. Each press of this button changes to the

e-11

4, 7, and 9-split screen sequentially. Only the 4 and 9 split screens are

 

available in the Triplex mode.

 

K.SEQUENCE

When pressed in the full screen mode, channels are switched automatically and sequentially within a specified time period.

L.FREEZE

Captures the selected screen as a still screen.

Refer to the section "When you want to watch in FREEZE screen mode" on page 21.

M.PIP

Selects the Picture in Picture mode.

N.ZOOM

When pressed in full screen mode, the screen is enlarged. Each press of this button enlarges the screen two and four times sequentially and then returns to the normal size. Use the Rotary Wheel to move the Zoomed-in screen.

O.Number Key(0 ~ 9)

Press the number of the channel to watch it in full screen mode.

Or, press the SYSTEM ID button and then press the number of the system you want to control with the remote control.

P.ZOOM(TELE/WIDE)

Only the remote control has this button. It is available only when a camera (SOC-420P, or SOC-920P, sold separately), is connected to the system.

Q.FOCUS(FAR/NEAR)

Only the remote control has this button. It is used for camera Focus control and available only when a camera (SOC-420P, or SOC-920P, sold separately), is connected to the system.

R.IRIS(CLOSE/OPEN)

Only the remote control has this button. It is used for camera Iris control and available only when a camera (SOC-420P, or SOC-920P, sold separately), is connected to the system.

S.ONEAF

Performs Auto Focus for the selected camera once in the present status. Only the remote control has this button. It is only available when a camera (SOC-420P, or SOC-920P, sold separately), is connected with the product.

T.SYSTEM ID

Selects the system to control with the remote. Only the remote control has this button.

U.ID RESET

Located on the remote control, this button resets the selected System ID to the default ID (1).