Information codes

When your washing machine malfunctions, you may see an information code on the display. If that happens, check this table and try the suggested solution before calling Customer Service.

CODE SYMBOL

SOLUTION

 

 

dE

Make sure the door is frmly closed.

Make sure that laundry is not caught in the door.

 

 

 

4E

Make sure the source water tap is turned on.

Check the water pressure.

 

 

 

5E

Clean the debris flter.

Make sure the drainage hose is installed correctly.

 

 

 

 

The laundry load is unbalanced. Redistribute the load. If only one item

UE

of clothing needs washing, such as a bathrobe or pair of denim, the

fnal spin result might be unsatisfactory and an “UE” error message

 

 

will be shown in the display window.

 

 

cE/3E

Call the after-sales service.

 

 

 

This occurs when too much foaming is detected. It is also displayed

Sud

while foaming is removed. When the removal is fnished, the normal

cycle proceeds.(This is one of the normal operations. It is an error for

 

 

preventing non-sensing faults.)

 

 

 

If the voltage of the supplied power is instable, the washing machine

Uc

will be paused to protect its electric devices.

 

If the correct voltage is supplied, the cycle will resume automatically.

 

 

For any codes not listed above, or if the suggested solution doesn’t fx the problem, call your Samsung Service Centre or local Samsung dealer.

calibrating your washing machine

Calibration mode

Samsung washing machine detects the laundry weight automatically. For more accurate weight detection, please run Calibration Mode after the installation. Calibration mode is done by following the steps below.

1.Remove laundry or any contents in the machine and turn off the machine.

2.Press the Temp button and Delay End button simultaneously, and press the Power button in addition. Then the machine turns on.

3.Press the Start button to activate “Calibration Mode”.

4.The drum rotates clockwise and counterclockwise approximately for 3 minutes.

5.When “Calibration Mode” is finished, “End(En)” appears on the display, and the machine automatically turns off. The washing machine is now ready for use.

chartlec 05 Cy

troubleshooting and information codes _37

WF1802WF-03061D-04_EN.indd 37

2013-7-20 10:03:07

Page 37
Image 37
Samsung WF1802WFVS/YLE manual Calibrating your washing machine, Information codes, Calibration mode, Code Symbol Solution