
Chapter 6 Basic setting and operation
2 Registering and deleting E-mail addresses
Click "Add
figure on the right. |
| |
✐ Up to 10 |
| |
Check / Delete | ||
| ||
To delete the registered addresses, check the address you want to |
| |
| ||
delete and click Delete button. |
|
3 Option selection for sending alert mail
Click Option sub menu tab. Check the condition items under which alert mail will be sent and click Set button.
Please refer to the item "Examples :Type and contents of alert mail" described on the next page.
Option
58
oWhen PJ lamp is off.
oWhen PJ lamp replacement time is reached.
oWhen internal PJ power circuit is failed.
oWhen internal PJ temperature is too high.
oWhen PJ is turned into Standby in proper user operation.
oWhen accumulated filter use time reaches
[ ] hours.
oWhen Power management function turns PJ lamp off.
oWhen the signal is interrupted.
oWhen Auto Play is failed.
oWhen lamp Corres. Value reaches
[ ] hours. Attached message
✐"When PJ lamp is off" signifies the lamp goes out without user operation. "When PJ is turned into Standby in proper user operation" signifies that the projector is turned on by using the web browser and then it is turned into standby with ON/STANDBY button on the top control or the remote control.
✐If condition "When Auto Play is failed" is checked, the trap is sent when the error occurs during the auto display operation using with the network viewer function (+p.113). For further information of the error, refer to item "Auto Display setting and control page [3]"(+p.128).
✐The length of message should be less than 255 characters.
✐Up to 99,999 hours can be set for use time.
✐The optional settings return to the factory default when you unplug the AC power cord of the projector.