Sanyo DWM-3500 AM/FM Antenna Connections, Power Supply Main Unit and Powered Subwoofer

AM/FM Antenna Connections

FM antenna

The FM indoor antenna lead wire is sufficient to receive most local FM signals.

1.Unwind the antenna lead wire.

2.Twist the end of the wire and pull it off.

3. Connect it to the rear FM 75 Ω terminal. See the illustration on the right.

4.Extend it as straight as possible and, while listening to the sound from the system, secure it in a position where the best FM reception is found.

In fringe areas, or where reception is distorted or noisy, an FM outdoor antenna (not supplied) should be connected instead of the FM indoor antenna lead wire. The terminals will accept 75- ohm coaxial cable.

AM antenna

The AM loop antenna is sufficient to
receive most local AM broadcasts.
Assemble the loop antenna.	1	2

Unwind the antenna wires, then connect them to the AM LOOP terminals. Place

the loop antenna in a position which1 yields the best AM reception, or attach

it to a wall or other surface as shown.

3

2

Screws (not supplied)

Note:

To minimize noise...

•Keep the speaker wires, power cord and all other system connection cables away from the loop antenna.

•Do not place the antenna close to a TV or speaker.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Power Supply

(Main Unit and Powered Subwoofer)

Connect the power cord to a 120V AC 60Hz outlet. This unit is equipped with a polarized plug. If you have difficulty inserting the plug, turn it over and reinsert it. If the unit will not be used for a long time, disconnect the AC plug from the AC outlet.

The powered subwoofer will automatically turn on when the main unit is turned on.

The POWER indicator lights on the powered subwoofer.

Notes:

•Before plugging the power cord into an AC outlet, make sure that all the connections have been made.

•The main unit and powered subwoofer are not disconnected from the AC power unless the power cord is unplugged from the AC outlet.

CAUTION:

When installing an outdoor antenna, follow the installation instructions in “IMPORTANT SAFETY INSTRUCTIONS” on page E2.

FM outdoor antennaGround (not supplied)

75-ohm coaxial cable (not supplied)

Antenna discharge unit (not supplied)

AM loop antenna

AMFMLOOP75￿	Black
	FM indoor
	antenna lead
	wire
	White

	DVDOUTPUTCOMPONENT	DVD/VCROUTPUT	AMLOOP			IN	VHF/UHF
S-VIDEO	Y	VIDEO	FM75￿AUDIOOUT
	B	L			)	(ANT)
	PR	RAUDIO	(6–	CHANNEL3 4		OUT
					CH	(TV)

Main unit

Need help? Call 1-800-813-3435

-E16-

2B80201A [E] P01-16 16 24/2/03, 7:13 PM