Sanyo DWM-3500 Stereo Recording and Playback, Separate Audio Program SAP, Audio Out

Stereo Recording and Playback

The VHS Hi-Fi audio system permits high fidelity recording of MTS STEREO TV broadcasts.

When a MTS STEREO broadcast is received, the word STEREO will appear on the TV screen and the program can be viewed or recorded in stereo.

The Hi-Fi STEREO recording procedure is the same as for normal recordings.

STEREO

Separate Audio Program (SAP)

Your VCR is fitted with a SAP broadcast system which enables you to switch to a separate audio program when viewing a selected channel.

This function applies only when the program is broadcast in multi-languages through the SAP broadcast system.

1, 4

3 2

Note:

When using a CATV system, stereo TV programs may be transmitted over a mono cable channel. In this case the word “STEREO” will not appear and the sound will be in mono.

Output selection

When viewing an MTS STEREO TV program, or playing a prerecorded VHS Hi-Fi STEREO videotape, press [AUDIO OUT] to select how the audio will be heard through the speakers. Normally set to the Hi-Fi STEREO position, this button can be set to the MONO position if the stereo broadcast or videotape audio is of poor quality. The “R” and “L” positions allow the audio from the Right or Left Hi-Fi channel to be heard over both TV speakers. This button has no effect when viewing a MONO videotape or TV program. Each time when you press the button, OUTPUT SELECTION display appears on the TV screen for several seconds. Refer to the chart below.

OUTPUT	SOUND HEARD ON BOTH
SELECTION	SPEAKERS
STEREO	STEREO
L ch	LEFT CHANNEL AUDIO
R ch	RIGHT CHANNEL AUDIO
MONO	MONO

AUDIO OUT

Notes:

•When playing back a tape that is not recorded in Hi-Fi stereo mode, the audio will automatically be monaural.

•When listening to a VHS Hi-Fi video tape or MTS broadcast through the VHF/UHF jack (Audio/Video cord not connected), the sound will be monaural.

1.Press [SETUP/MENU].

The “MENU” screen appears on the TV screen.

MENU
TIMER REC SET	ON	OFF
AUTO REPEAT
SAP	ON	OFF
CH SETUP
SYSTEM SETUP
SPEAKER SETUP

TVGuardian SETUP 〈4/5/ENTER/MENU〉

2.Press [4] or [5] to select “SAP”.

3.Press [ENTER] to select “ON”.

MENU
TIMER REC SET	ON	OFF
AUTO REPEAT
SAP	ON	OFF
CH SETUP
SYSTEM SETUP
SPEAKER SETUP

TVGuardian SETUP 〈4/5/ENTER/MENU〉

4. Press [SETUP/MENU] until the menu screen is cleared.

Listening to SAP

When the VCR is turned on or a channel selection is made, make certain the letters “SAP” appears on the TV screen. This means that the “Separate Audio Program” broadcasting is available.

STEREO SAP SAP

OR

-E36-

2B80201A [E] P27-37 36 24/2/03, 7:14 PM