Receiving a Sprint PCS Ready Link Call

To receive a Sprint PCS Ready Link call:

1.Make sure your phone’s Sprint PCS Ready Link mode is enabled (see “Setting Sprint PCS Ready Link Mode” on page 140).

2.When you receive a Sprint PCS Ready Link call from a contact, “R-Link Call,” the contact’s name, and the Sprint PCS Ready Link number appear on the display. (You do not need to take any action to answer the call.)

When you receive a group call, “Group Call” and the Sprint PCS Ready Link number appear.

If nobody takes the floor for 20 seconds, the call will be a missed Ready Link call.

3.If the person placing the call has kept the floor (held the Ready Link/Memo button), you will see the contact name and Sprint PCS Ready Link number along with “has floor.,” and you will hear the caller speaking.

4.When the caller finishes speaking and releases , you will

see “Floor is open.” on the display screen. Press and hold to take the floor and reply to the caller. (You will see “You have floor.” and hear a tone confirming that you may speak.)

5.When the conversation is finished, press .

Tip: You can also receive a Sprint PCS Ready Link call with the flip closed. Press

and hold to take the floor when the floor is open.

Note: You can change the volume and the speakerphone setting while a

Sprint PCS Ready Link call is activated. Volume: Adjust the voice volume by using the Side Volume key or by pressing the navigation key up or down except when

you are pressing and holding . Speaker: Switch the speakerphone on or off by

pressing .

Section 2J: Using Sprint PCS Ready Link

147

Page 160
Image 160
Sanyo MM-7400 manual Receiving a Sprint PCS Ready Link Call, To receive a Sprint PCS Ready Link call